end_request: I/O error, dev sr2, sector 62968
squashfs: version 3.4 (2008/08/26) Phillip Lougher
kjournald starting.  Commit interval 5 seconds
EXT3 FS on dm-0, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
SELinux:  Disabled at runtime.
SELinux:  Unregistering netfilter hooks
udevd version 127 started
tg3.c:v3.94 (August 14, 2008)
tg3 0000:02:00.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
tg3 0000:02:00.0: setting latency timer to 64
eth0: Tigon3 [partno(BCM95751) rev 4001 PHY(5750)] (PCI Express) 10/100/1000Base-T Ethernet 00:11:11:cb:06:49
eth0: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] WireSpeed[1] TSOcap[1]
eth0: dma_rwctrl[76180000] dma_mask[64-bit]
[drm] Initialized drm 1.1.0 20060810
pci 0000:01:00.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
pci 0000:01:00.0: setting latency timer to 64
[drm] Detected VRAM RAM=131072K, accessible=131072K, BAR=131072K
[drm] Default TV standard: NTSC
[drm] 27.000000000 MHz TV ref clk
[drm] DFP table revision: 4
intel_rng: Firmware space is locked read-only. If you can't or
intel_rng: don't want to disable this in firmware setup, and if
intel_rng: you are certain that your system has a functional
intel_rng: RNG, try using the 'no_fwh_detect' option.
i2c-adapter i2c-0: unable to read EDID block.
i801_smbus 0000:00:1f.3: PCI INT B -> GSI 17 (level, low) -> IRQ 17
pci 0000:01:00.0: VGA-1: no EDID data
iTCO_vendor_support: vendor-support=0
input: PC Speaker as /devices/platform/pcspkr/input/input6
iTCO_wdt: Intel TCO WatchDog Timer Driver v1.03 (30-Apr-2008)
iTCO_wdt: Found a ICH6 or ICH6R TCO device (Version=2, TCOBASE=0x0860)
iTCO_wdt: initialized. heartbeat=30 sec (nowayout=0)
Linux video capture interface: v2.00
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
saa7130/34: v4l2 driver version 0.2.14 loaded
saa7134 0000:04:02.0: PCI INT A -> GSI 18 (level, low) -> IRQ 18
saa7133[0]: found at 0000:04:02.0, rev: 17, irq: 18, latency: 64, mmio: 0xdfaff800
saa7133[0]: subsystem: 1421:0380, board: UNKNOWN/GENERIC [card=0,autodetected]
saa7133[0]: board init: gpio is 0
dcdbas dcdbas: Dell Systems Management Base Driver (version 5.6.0-3.2)
allocated f4179000 1280x1024 fb: 0x000c0000, bo f37e7600
fbcon: radeondrmfb (fb0) is primary device
Console: switching to colour frame buffer device 160x64
saa7133[0]: i2c eeprom 00: 21 14 80 03 54 20 1c 00 43 43 a9 1c 55 d2 b2 92
saa7133[0]: i2c eeprom 10: 00 ff 82 0f ff 20 ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 20: 01 40 01 02 02 ff 01 04 08 ff 00 fe ff ff ff ff
saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 40: ff 18 00 c0 86 00 ff 00 00 00 ff ff ff ff ff ff
saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 80: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 90: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom a0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom b0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom c0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom d0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom e0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom f0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: registered device video0 [v4l2]
saa7133[0]: registered device vbi0
[drm] TMDS-9: set mode 1280x1024 15
fb0: radeondrmfb frame buffer device
registered panic notifier
[drm] Loading R300 Microcode
[drm] Num pipes: 1
[drm] writeback test succeeded in 1 usecs
[drm] Initialized radeon 1.29.0 20080528 on minor 0
Intel ICH 0000:00:1e.2: PCI INT A -> GSI 23 (level, low) -> IRQ 23
Intel ICH 0000:00:1e.2: setting latency timer to 64
ALSA sound/pci/ac97/ac97_codec.c:2122: AC'97 0 analog subsections not ready
intel8x0_measure_ac97_clock: measured 50447 usecs
intel8x0: clocking to 48000
device-mapper: multipath: version 1.0.5 loaded
EXT3 FS on dm-0, internal journal